- Learn How to Scratch Build Tanks #1 – Gathering Supplies
- Scratch Building Tanks Tutorial #2 – The Basic Structure
- Scratch Building Tanks Tutorial #3: Turret, Armor Plates, and Rivets
- Scratch Building Tanks Tutorial #4: Going beyond the template
- Scratch Building Tanks Tutorial #5: Adding Tracks
- Scratch Building Tanks Tutorial #6: Adding Weapons
- Scratch Building Tanks Tutorial #7: Finishing Touches
- Scratch Built Devil Dog Painted
- Scratch Built Tank vs. GW Chimera Part 1: Early build comparison
- Scratch Built Tank vs. GW Chimera Part 2: Finished Build Comparison
In my last post I started building a chimera from the GW kit while also scratch building one using any bits I could squeeze out of the kit. This week I will show how I finished both builds and compare the results.
I ended the last post with one GW chimera and one scratch built chimera with the basic structure, tracks, and weapons built.
After that I finished the track guards, turret hatch, and some other details on the scratch build. I won’t cover those in detail here as you can see the same kind of work in in the third part of my Devil Dog build.
The Chimera kit comes with an optional Dozer Blade. I don’t always take them but they can be very handy when you need one so I want to magnetize it. The first thing I did was attach the dozer blade to the mount. Then I drilled two 1/8″ pits and glued the magnets into them.
I added marks to the sides so I can see where the magnets are from the other sides. Then I dry-fit the assembly to the GW chimera and transferred marks to the tank. Then I drilled two holes and glued in magnets to hold the blade in place. For the scratch build I added a plate of .040 styrene, punched two holes with a 1/8″ hole punch, pressed the magnets into the holes, and glued it all to the bottom of the tank. Now I can pop the dozer blade onto either tank. I didn’t grab a picture of the magnets on the GW chimera but it doesn’t look much different from the scratch built one.I found a little piece in the template that fits nicely on the side of the turret to use as an accessory mount. It’s actually supposed to go on the back as a communications piece but I like it here. I reinforced it with some styrene on the top and bottom, and sank a magnet into the top piece. I also added an attachment point on the track guard to hold another magnet. I added magnets to the searchlight and smoke launchers from the kit so they will fit on any of my attachment points.
I used .040 styrene sheet to build a similar accessory mount on the GW turret. The searchlight in the picture is the one I scratch built for my Devil Dog, you can see how I did it in that tutorial. I also added an attachment point on one track guard to hold the other searchlight. These points could also be used to hold a pintle mounted heavy stubber if I chose to. Now that I have both tanks basically finished you can see a good side by side comparison. The GW bits add a lot of detail to the scratch build for relatively little effort. Once they are painted it will be difficult to tell which is which without looking closely. Before painting these I will add some more attachment points so I have room for all of the upgrades I’m likely to take. I’ll also add some stowage, damage, and grotty decorations. I’m at the point with these that everything else is conversion work beyond the standard kit so this is a good place to make the direct comparison. As I said in the last post the scratch build was about four times as much work as the GW kit. It looks pretty good but it isn’t quite as square or as detailed as the GW kit. If you have the cash you’ll get better results from the GW kits with much less effort. But if you’ve got the time an patience you can save a bunch of money by scratch building and still have some good looking tanks. If you go this route I definitely recommend you sprinkle in a couple of kits or just some bits as having those few extra details can make a big difference to your scratch build.